Pulpdent Porcelain Etch Gel 4.8ml

Pulpdent Porcelain Etch Gel 4.8 ml

Pulpdent Porcelain Etch Gel is a high-quality ceramic etching gel designed for rapid and controlled surface preparation of porcelain restorations prior to bonding. With a one-minute etching protocol, it effectively conditions crowns, veneers, inlays, and fractured porcelain surfaces without staining ceramic or composite materials.

Brand: :contentReference[oaicite:1]{index=1}

Features

• Does not stain ceramic or composite materials
• One-minute etching protocol for most porcelains
• Thixotropic consistency – stays precisely where placed
• Buffered formulation for controlled etching
• Washes off easily with water

Indications

• Etching of porcelain crowns, veneers and inlays
• Surface preparation of fractured porcelain prior to bonding
• Porcelain repair and adhesive cementation procedures

Packaging

• 1 x 4.8 ml Syringe

Directions to Use

1. Protective eyewear must be worn by the practitioner, assistant and patient. Protective gloves must be worn by the practitioner and assistant.
2. Place a rubber dam to isolate the operative site and protect soft tissue.
3. The assistant should hold a vacuum tip 2–3 inches from the porcelain surface during etching to evacuate acid fumes.
4. Securely attach a 25-gauge Luer-lock applicator tip. Start gel flow on a pad and discard this sample. Do not initiate flow intraorally. Use a new applicator tip for each patient.
5. Apply Porcelain Etch Gel to the porcelain surface and leave for 1 minute while evacuating fumes.
   • For lithium disilicate restorations: etch for 10–15 seconds.
   • For etch-resistant ceramics, air abrasion and mechanical retention are recommended.
6. Rinse thoroughly with copious amounts of water and dry using clean, oil-free air.
7. Apply silane (e.g., Pulpdent Silane Bond Enhancer) or proceed according to the instructions of the selected bonding or repair system.
8. Continue with porcelain repair or cementation of crowns, veneers or inlays.